To Next Page

To Previous Page

Load Function

3. Select 1. LIST: Off and press [Enter].

4. Press the Left/Right key to select Open and press [Enter].

5. Select USB and press [Enter].

At this point, the system will automatically read all the List files in the root di-

rectory of the USB flash drive. The interface is displayed as follows:

XXX.csv

Not-Load Load YY/ZZ

XXX indicates the name of the List file; YY indicates the serial number of the

current List file; ZZ indicates the total number of the List file.

6. Press the Up/Down key to select the List file.

7. Press the Left/Right key to select Load, press [Enter] to complete the im-

port, and wait for the trigger to run this List file.

At this point, the interface returns to the main interface of the system and

Lxx/xxxx WTG is displayed in the lower right corner.

Select Internal List Program

You can select a List file saved inside the instrument to be in the Open state

and wait for subsequent triggers to run. The procedures are as follows:

1. Press the composite keys [Shift]+[I-set] (Function) on the front panel to en-

ter the function menu.

2. Select 1. LIST: Off and press [Enter].

3. Press the Left/Right key to select Open and press [Enter].

4. Press the Left/Right key to select Internal and press [Enter].

5. Set the name of the List file to be recalled (that is, the file name set in Edit),

and press [Enter].

The interface returns to the main interface of the LIST function, which is dis-

played as follows:

FUNCTION LIST

Run Open Edit Export

If you select Run and press [Enter], the instrument will enter LIST mode

and wait for the trigger to run.

Export List Program

Supports exporting the internal List file to an external USB flash drive. The ex-

ported List file is saved in .csv format.

1. Insert the USB flash drive into the front panel USB connector.

ITech IT8000 Series User Manual

Other manuals for ITech IT8000 Series