ITech IT8000 Series User Manual

Basic Operation
• The voltage, current, power, resistance setting values displayed on the main
interface when the instrument is powered on.
• The working mode displayed on the main interface when the instrument is
powered on.
• Parameter setting values in the Config menu.
• The input state of the load, i.e., the [On/Off] key state.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the PowerOn and press
[Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• Reset: Default value, indicates when the instrument is powered on, the
instrument will initialize some parameter settings or state.
The affected parameters and the reset information are as shown in the
following table.
Table 5–1 Initial value of the parameter
Category Parameter Initial Value
Main
interface
Voltage setting under CV
mode: Vs
Rated voltage of the
instrument
Current setting under CC
mode: Is
0A
Power setting under CW mode:
Ps
0W
Resistance setting under CR
mode: Rs
Rated maximum resist-
ance value of the
instrument
Voltage setting under CVCC
mode: Vs
Rated voltage of the
instrument
Current setting under CVCC
mode: Is
0A
Voltage setting under CVCR
mode: Vs
Rated voltage of the
instrument
Copyright © Itech Electronic Co., Ltd.
71

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English