2-82
CHASSIS MODIFICATIONS
D
AILY 4x4
Base - May 2007 Print 603.93.761
Electrical System: Modifications and Drawing-Off Power
El ectr i cal Sys tem: Modi fi cati ons and Dr awi ng- --Of f Powe r
2.18 Retarder Installation
Not applicable to the vehicle.
2.19 Modifications to t he Rear Underrun
Our vehicles are fitted with a rear underrun bar in accordance with EC Directives.
The maximum permitted distance from the bar to the rearmost part of the body is 400 mm, deducting the distortion found during
approval tests (10 mm on average).
Whenever the chassis modifications affect the rear overhang, the underrun bar must be repositioned (in compliance with current
regulations) keeping the same con nection with the chassis as the original veh icle.
When modifying the vehicles or installing special equipment (e.g. tail lifts) it may be n ec essary to modify the structure of the underrun
bar. Such modifications must not change the original resistance and stiffness specifications (so as to comply with local government
regulations, if any). The company carry ing out the modification / installation must where required, su bmit the necessary docu ment
demonstrating compliance w ith legislation in force at th e time.
In the event that a different under run-bar has to be fitted, compliance with the standards and regulations in force must be checked.
Test certificates and documentation must, wh ere required, be submitted to the respective government agenc y.
To Next Page
Loading...
Need help?
General
