Operating the Operating Panel
62
No. Element Description Reference
1Before starting
the job
• Top task from the main menu
[Cases]
• Examples: Water change, filter
change, insert block, insert tool,
etc.
• Device-related tasks:
“Status displays in the
section
[Maintenance]”,
page 69
• Block-related tasks:
“Status displays in the
section [Blocks]”,
page 70
• Tool-related tasks:
“Status displays in the
section [Tools]”,
page 70
• “Preparing milling
jobs”, page 89
No symbol All tasks completed
With running
jobs: Symbol
Perform emergency stop “Performing an
emergency stop”,
page 111
2 Device status Device-related tasks which must be
processed (if applicable)
-
3 Status bar milling
job
• Left: Elapsed time
• Right: Total milling duration for
all running and pending milling
jobs
-
4 Milling duration Total remaining time (in hh:min) for
all pending and running milling
jobs
-
5 Milling jobs Number of pending or running
milling jobs
-
6 Symbols to start
and pause the
milling jobs
(symbol situation-
dependent)
Milling jobs can not yet
be started. Tasks must be
performed.
“Preparing milling jobs”,
page 89
Milling jobs can be
started
• “Starting individual
milling jobs (Single
mode)”, page 107
• “Starting several
milling jobs (Multi
mode)”, page 108
Milling jobs are paused “Pausing the processing
of milling jobs after the
current milling job and
then continuing again”,
page 110
Pause further milling
jobs after this current
running job
To Next Page
Loading...