7
1 Indications
Intended purpose
Furnace for dental restorations for the sintering and glazing of zirconium oxide materials such as IPS e.max ZirCAD as well
as for the crystallization and glazing of e.g. IPS e.max CAD.
Use
The Programat CS6 is a sintering, crystallization and glazing furnace for the dental field. It was specifically
developed for use in the dental office. The firing chamber may be heated up to max. 1560°C (2192°F) by means of a heating
element. Furthermore, the firing chamber has been designed in such a way that a vacuum may be created with a vacuum
pump. Electronic components with the corresponding software monitor and control the firing programs. Additionally, the
set and actual temperatures are continuously compared.
Use the Programat CS6 exclusively for the sintering, crystallization or glazing of dental ceramic materials. Other uses than
the ones stipulated, e.g. cooking of food, firing of other materials, etc., are contraindicated. The manufacturer does not
assume any liability for damage resulting from misuse. The user is solely responsible for any risk resulting from failure to
observe these Instructions.
Further instructions to assure proper use of the furnace:
– The instructions, regulations and notes in these Operating Instructions must be observed.
– The instructions, regulations and notes in the material's Instructions for Use must be observed.
– The furnace must be operated under the indicated environmental and operating conditions (see Chapter 6)
– The Programat CS6 must be properly maintained.
Additional information
The device has been developed solely for use in dentistry. Start-up and operation should be carried out strictly according to
the Operating Instructions. Liability cannot be accepted for damages resulting from misuse or failure to observe the
Instructions. The user is solely responsible for testing the apparatus for its suitability for any purpose not explicitly stated in
the Instructions.
Signs and symbols
The signs and symbols in these Operating Instructions facilitate the finding of important points and have the following
meanings:
Symbol Note
Observe Operating Instructions
Risks and dangers
Contraindication
Warning, hot surface (burn hazard)
Beware of hand injuries (risk of crushing)
Important information
To Next Page
Loading...
