CONTROLS 4
en-44
4.2.23.51 LANGUAGE MENU _____________________________________________________
Select the language and accept
On the page for the language options, Press
the button to select, press the button up
and down to move the
. When the is
moved up and down the languages, it does not
change until button is pressed to store the
language. When the title bar, i.e. the
'Language Menu' will change to the new
language.
The options will be in the correct language i.e.
English, Deutsch, Francais, Dansk, Svensk,
Nederlands and Español.
Press the button to return to previous menu.
WARNINGS
4.2.23.52 WARNING SLOPE ANGLE - ANGLE ALERT _________________________________
During work if the machine is driven on a slope of 16° the screen will display this
warning. This over rides all other information, and will continue until the machine
has been driven to an area with a slope of less than 16°.
Press the button below the
to confirm the fault.
4.2.23.53 WARNING SLOPE ANGLE - INHIBIT LIFT ___________________________________
If the slope angle reaches 19° the screen will display this warning which indicates
that the cutting unit arms are locked in the current position and will continue to run
but cannot be re engaged, until operating below 19°. An audible warning will be
sounded, the warning will sound four times every 4 seconds and the red LED’s will
flash four times every 4 seconds. This will continue until the machine has been
driven to an area with a slope of less than 19°.
Press the button below the
to confirm the fault.
Language
English
Deutsch
Francais
Dansk
Svensk
Netherlands
Espanol
Main Menu
Clock
Service
Settings
Language
0°
Slopes > = 16°
in either x or y
0°
Slopes > = 19°
in either x or y
To Next Page
Loading...
Need help?
General
