4 CONTROLS
en-43
4.2.23.49 FAN DRIVE ___________________________________________________________
Select the Fan Drive and accept .
The normal fan operation is based on engine
temperature. Fan speed will increase as
engine temperature increases.
When engine temperature exceeds a set value
or timer ends, the reverse fan cycle will start.
Fan will stop the forward rotation, operate in
reverse rotation for 10 seconds and return to
forward rotation. Timer will automatically
restart after each reverse fan cycle.
To prevent reverse fan rotation select
OFF
and select . To accept.
To use manual start the reverse fan cycle, select
Manual and select . To accept.
Press the button + and – to increase or decrease Timer Set-Up. Select . To accept.
4.2.23.50 BRIGHTNESS ADJUST__________________________________________________
Use the buttons below the + and - icons on the screen to increase and decrease
the brightness.
Pin Menu
Cruise Control
Cross Cut
Vehicle Speed
Change PIN
Inclinometer
Set Default Parameters
Drive Modes
Fan Drive
min
Fan Drive Menu
30
Timer Set-Up [min]
Manual
OFF
To Next Page
Loading...
Need help?
General
