CONTROLS 4
en-42
4.2.23.46 INCLINOMETER________________________________________________________
Select to shows TST status, Enabled or
Disabled.
Press the button up and down to move
between Enabled or Disabled Select . To
accept.
4.2.23.47 SET DEFAULT PARAMETERS ____________________________________________
Select the Set Default Parameters and
accept .
Select . To accept.
Press the button up and down to move
between YES or NO Select . To accept.
4.2.23.48 DRIVE MODES _________________________________________________________
Select the Drive Modes and accept .
Select . To accept.
Press the button up and down to move
between YES or NO Select . To accept.
Pin Menu
Cruise Control
Cross Cut
Vehicle Speed
Change PIN
Inclinometer
Set Default Parameters
Drive Modes
Fan Drive
TST Setting
TST Status Not Fitted
Pin Menu
Cruise Control
Cross Cut
Vehicle Speed
Change PIN
Inclinometer
Set Default Parameters
Drive Modes
Fan Drive
SET Default Param Values
Press Push Buttons To SET
Default Parameters Values
Pin Menu
Cruise Control
Cross Cut
Vehicle Speed
Change PIN
Inclinometer
Set Default Parameters
Drive Modes
Fan Drive
Drive Modes
Auto Mode Selectable Yes
Manual Mode Selectable Yes
Creep Mode Selectable Yes
To Next Page