Wireless Network Connection XT200 User Manual
Janam Technologies LLC Version 2, April 2020 Wireless Network Connection 4—2
Connecting the XT200 to a Wireless Local Area Network (WLAN)
To initially connect the XT200 to a wireless local area network, go to Settings > Network & Internet
> W-Fi. Turn Wi-Fi on. The XT200 will begin searching for available Wi-Fi networks. After a few
seconds it will list what it has found, including the approximate signal strength and whether or not a
network is secured by a password or not. Tap on your preferred network. Enter the password. The
connection will be established. Upon successful completion, the network link will show up as
Connected.
If you tap on the network you are connected to,
a window pops up that shows information about
the connection, including signal strength, link
speed, frequency, and the type of security. Here
you can also opt to forget this network, so that
next time you come within range of it, the XT200
will not automatically connect.
In Settings > Network & Internet, you may
also tap the options button on the upper
righthand corner. This launches a pop-up from
where you can Reset Wi-Fi, mobile &
Bluetooth.
To Next Page
Loading...
