Janome MyLock 744D - Attaching the Waste Chip Box; Storing the Accessory Box; Standard Accessories; Storing the Needle Threader

Attaching the Waste Chip Box
Insert the hook into groove on looper cover.
q Groove
r
w Looper cover
e Waste chip box
r Hook
q
e
w
Storing the Accessory Box
Insert the accessory box into the waste chip box.
q Waste chip box
w Accessory box
w
q
q w e r t
Standard Accessories
q Screwdriver (Large)
w Screwdriver (Small)
e Tweezers
y u i m
r Set of needles No.11, No.14
t Nets
y Spool holder caps
u Lint brush
i Needle threader
0 1 2 3
q
e w
m Oil
0 Spreader
1 Spanner
2 Upper knife
3 Attachment mounting plate
Storing the Needle Threader
You can store the attached needle threader inside of
the looper cover in the holder.
The holder is very convenient. You can use the
needle threader whenever you desired if it is stored
in the holder after using the needle threader. Push
the needle threader into the holder to store it.
q Looper cover
w Holder
e Needle threader
10