Janome MyLock 744D - Connecting the Machine to the Power Supply; Controlling Sewing Speed

Connecting the Machine to the Power Supply
t 1. Turn off the power switch, and connect the
e
r
machine plug to the machine socket.
2. Connect the power supply plug to your power
w
supply.
2
1
3. Turn on the power switch.
q Power switch
q
w Machine plug
e Machine socket
r Power supply plug
t Power supply
y Speed controller
y
3
Controlling Sewing Speed
Sewing speed can be varied by the speed controller.
The harder you press on the controller, the faster the
machine runs.
Step on the speed controller with the presser foot
lifter up, and practice controlling the speed.
q
q Speed controller
For Your Safety:
* While in operation, always keep your eye on the
sewing area, and do not touch any moving parts
such as the thread take-up lever, loopers,
handwheel, needle or knives.
* Always disconnect the machine from the power
supply:
— when leaving the machine unattended.
— when attaching or removing parts.
— when threading or cleaning the machine.
* Do not place anything on the speed controller,
except when the machine is in use.
12