Janome MyLock 744D - The Position of Thread Guide Bar; Attaching the Spool Holder Cap and Net

q
The Position of Thread Guide Bar
1. Pull the thread guide bar up as far as it will go.
2. Turn the thread guide bar so that the thread
w
guides are right above the spool pins.
q Thread guide bar
w Thread guide
e Stoppers
e
r Spool pin
* Make sure the two stoppers on the thread guide
r
shaft, as shown, are set in at the correct position.
1, 2
Attaching the Spool Holder Cap and Net
e
1. When you use a small thread spool, pull out the
q
r
spool holder from the spool pin. Then place the
spool with its slit side up, and put the spool
holder cap on top of it.
w
q Spool holder
w Spool pin
e Spool holder cap
r Slit
1
2. If the thread slips down from the spool
during threading and/or sewing, put a net on the
spool as illustrated to prevent jamming.
q Net
w Spool pin
w
q
2
16