Janome MyLock 744D - 10. Move the lower looper to its rightmost position...

r
t
u
y
4, 5, 6, 7
o
i
4. Hook the thread on the corner , and then pass
the thread through the looper thread guide.
5. Pass the thread through the changeable thread
guide.
6. Pass the thread through the looper thread
take-up lever (lower).
7. Pass the thread through the lower looper thread
guide (1).
r Looper thread guide
t Changeable thread guide.
y Looper thread take-up lever (lower)
u Lower looper thread guide (1)
8. Turn the handwheel toward you to move the lower
looper to the right side.
Then lift up the lower looper thread guide (1).
When you do this, the lower looper thread guide
(2) and (3) are moved to the right for easy
threading.
Pass the thread through the lower looper thread
guide (2).
9. Pass the thread through the lower looper thread
guide (3).
i Lower looper thread guide (2)
o Lower looper thread guide (3)
8, 9
Holding the end of the thread, push the lower looper
o
thread guide (1) down with your other hand to return
it to its original position.
Lower looper thread guides (2) and (3) will return to
their original position automatically.
* You can return the lower looper thread guide (1),
(2) and (3) to their original position automatically
by turning the handwheel counterclockwise.
40