65
Remark:0: terminal invalid 1: terminal invalid
13: acceleration / deceleration selection 1
14: acceleration / deceleration selection 2
4 kinds of acceleration / deceleration times can be selected by acceleration /
deceleration selection terminal l and 2.
15. Frequency increasing signal (Up signal)
When this terminal is valid, the frequency increases at a constant speed, until
operative frequency is highest.
16. Frequency decreasing signal (Down signal)
When this terminal is valid, the frequency decreases at a constant speed, until
operative frequency is lowest.
Attention: Inverter will not memorize the frequency setting changed by “UP” and
“DOWN” signal. When power is turned off and reset again, inverter still
memorizes the set value in P100.
0
0
Acceleration/ deceleration time 1
(P107,
P108)
1
0
Acceleration/ dec eleration time 2
(P401,
P402)
0
1
Acceleration/ deceleration time 3
(P403,
P404)
1
1
Acceleration/ deceleration time 4
(P405,
P406)
Acceleration / deceleration status
and result
Multi-function terminal
Acceleration/
deceleration
selection 1
Acceleration/
deceleration
selection 2
6
Chapter 6 Description of parameter setting
FC100 Series User Manaul
To Next Page
Loading...
Need help?
General
