NT-2000 REF Manual
Customizing Operation via Menu System
4-16
4.10.6. Outputting NAVTEX Messages of Specific Message Type
If you wish to output all messages of a specific message type, carry out the following
step–by–step instructions:
NOTE: A forced carriage return
(
)
will be replaced by an underscore
( _ ) (
hex 5F
)
when it
is output to a PC terminal or a printer
.
(1) Highlight option “5:MSG SELECTED BY TYPE” on the SELECT OUTPUT
MESSAGES submenu, and then press
. This turns on another submenu with a
list of message types, enabling you to select the desired message type, as in the
example illustrated below:
Figure 4-23 Outputting Stored Messages of Message Type D – Example
(2) Using
/
, highlight the desired message type, and then press
. The
following window will pop up to indicate the outputting action in progress.
The window will be turned off automatically upon completion of outputting.
To cancel the action, press
.
(3) Press
to return to the previous menu or
to return to the first receiver
message screen.
6: SELECT OUTPUT MESSAGES
1: RECEIVING MSG ON IOFFI
2: ALL STORED MSG
3: MSG SELECTED BY FREQUENCY
4: MSG SELECTED BY STATION
5: MSG SELECTED BY TYPEi
6: DISPLAYED MSG – ALL
7: DISPLAYED MSG – SPECIFIC
Select desired message type with
/
,
and then press
.
5:MSG SELECTED BY TYPE
A B C iDi E F G H I J K L M
N
O P Q R S T U
W
Z
OUTPUTTING ALL STORED MESSAGES.
TO CANCEL, PRESS
[
CLR
]
.
To Next Page
Loading...