40
E23 Speed not reached
Code C28 492203
Complaint Lowering the wheel guard the motor spins the wheel and then the display show E23
Root cause Balancing speed not reached
Service Code C54, C60, C110, C115, C84, C88
Actions to do
Check the wing nut.
Check the belt
Check the capacitor,
Check the motor wiring.
Check the motor pulley.
Check the motor.
Checl the Integrated Display.
E31 Rim only mounted during geometric matching
Code C28
Complaint At the end of the measurement run, the balancer shows E31
Root cause Rim only mounted during geometric matching when rim and tyre expected.
Service Code
Actions to do Repeat the measurement with a bare rim.
E83 Vibration of the machine disturbs the unbalance measurement
Code C28
Complaint At the end of the balancing process, the display shows E83
Root cause
Excessive vibration of the balancer.
Excessive vibration of the vibratory system
Service Code C102
Actions to do
Make sure that the vibratory system is properly secured to the cabinet
Make sure that the balncer is properly installed.
E88 The rotating speed of the main shaft exceeds the safety limit
Code C28 492208
Complaint During the balancing the display shows E88 and then the wheel is stopped
Root cause The main shaft is rotating at higher speed compared to the expectetionof the microprocessor
Service Code C56, C74, C75
Actions to do
Make sure about the proper adjustment of the wheel guard switch.
Check the proper connection of the wheel guard wires and connector
Check the plugs, connectors and cables concern the motor and encoder.
Check the position reading of encoder by C74.
E89 Key contact or pedal switch closed
Code C28
Complaint After switching on the balancer, the display shows E89
Root cause
Key pad contact
Pedal switch closed
Service Code C56
Actions to do
Release the Key pad button.
Replace the key pad.
Release the switch.
Replace the switch.
To Next Page
Loading...