JohnBean B9800 - Page 46

46
0X001005 PO EEP2 RD
Turn o! and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the Optoencoder.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001006 PO EEW1 WR
Turn o! and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the IBP2 box.
If the problem still persists:
Call Snap On
C codes C74, C75, C86, C115, C84, C88
0X001007 PO EEW2 WR
Turn o! and back on the machine.
If the problem still persists:
Load the software.
If the problem still persists:
Replace the Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C codes C74, C75, C85, C86, C122, C115, C84, C88
0X001020 DC OVERRUN
Check if the main shaft turns free.
If the problem still persists:
Check if the brake is correctly adjusted.
If the problem still persists:
Check the main shaft Optoencoder
If the problem still persists:
Check the main shaft polygonal ring.
If the problem still persists:
Call Snap On
C codes C74, C75, C85, C86, C115, C84, C88