47
0X001021 IEM ZERO MISMATCH
Check wing nut
If the problem still persists:
Check the shaft.
If the problem still persists:
Check the wheel clamping.
If the problem still persists:
Check the main shaft Optoencoder ! at cable.
If the problem still persists:
Check the main shaft Optoencoder.
If the problem still persists:
Check the IBP box
If the problem still persists:
Call Snap On
C Codes C74, C75, C85, C86, C115, C84, C88
0X001023 SPEED FLUCTUATION DURING THE MEASUREMENT
Check the belt tension.
If the problem still persists:
Check the speed with C60.
If the problem still persists:
Check Optoencoder with C54.
If the problem still persists:
Check the capacitor
If the problem still persists:
Call Snap On
C Codes C28, C54, C60
0X001024 NOISY SIGNAL FROM TRANSDUCERS DURING MEASURING RUN
Check if the machine is well placed on the ! oor.
If the problem still persists:
Check if the balancer components vibrate.
If the problem still persists:
Check the belt tension.
If the problem still persists:
Check the bearings.
If the problem still persists:
Check the transducers
If the problem still persists:
Check if the vibratory assu is well secured to the cabinet.
If the problem still persists:
Call Snap On
C Codes C28
To Next Page
Loading...