362247-BIM-B-0109
Johnson Controls Unitary Products 5
REFERENCE
Additional information is available in the following refer-
ence forms:
• Technical Guide - DW-03 thru -05, 282906
• General Installation - DW-03 thru -05, 362247
RENEWAL PARTS
Contact your local UP parts distribution center for
authorized replacement parts.
APPROVALS
Design listed by CSA as follows:
• For use as a cooling unit only with or without
optional electric heat.
• For use as a forced air furnace with cooling
unit
• For outdoor installation only.
• For installation on combustible material.
• For use with natural gas or propane gas.
The installer should pay particular attention to the
words: NOTE, CAUTION and WARNING. Notes are
intended to clarify or make the installation easier. Cau-
tions are given to prevent equipment damage. Warn-
ings are given to alert installer that personal injury and/
or equipment damage may result if installation proce-
dure is not handled properly.
This product must be installed in strict compli-
ance with the enclosed installation instructions
and any applicable local, state, and national
codes including, but not limited to, building,
electrical, and mechanical codes.
Improper installation may create a condition
where the operation of the product could cause
personal injury or property damage.
To Next Page
Loading...
