362247-BIM-B-0109
Johnson Controls Unitary Products 7
INSTALLATION
INSTALLATION SAFETY INFORMATION:
Read these instructions before continuing this appli-
ance installation. This is an outdoor combination heat-
ing and cooling unit. The installer must assure that
these instructions are made available to the consumer
and with instructions to retain them for future reference.
1. Refer to the furnace rating plate for the approved
type of gas for this furnace.
2. Install this furnace only in a location and position
as specified on page 8 of these instructions.
3. Never test for gas leaks with an open flame. Use
commercially available soap solution made specifi-
cally for the detection of leaks when checking all
connections.
4. Always install furnace to operate within the furnace's
intended temperature-rise range with the duct sys-
tem and within the allowable external static pressure
range, as specified on the unit name/rating plate.
5. This equipment is not to be used for temporary
heating or cooling of buildings or structures under
construction.
LIMITATIONS
These units must be installed in accordance with the
following national and local safety codes:
In U.S.A
.:
• National Electrical Code ANSI/NFPA No. 70.
• National Fuel Gas Code Z223.1.
• Gas-Fired Central Furnace Standard ANSI
Z21.47a.
• Local gas utility requirements.
In Canada
:
• Current Canadian Electrical Code C22.1.
• Current Gas Installation Codes CSA-B149.1.
• Local plumbing and waste water codes.
• Other applicable local codes.
Refer to the Unit Application Data Table 1 and to the
Gas Heat Application Data Table 4.
If components are to be added to a unit to meet local
codes, they are to be installed at the dealer's and/or
the customer's expense.
Size of unit for proposed installation should be based
on heat loss/heat gain calculation made according to
the methods of the Air Conditioning Contractors of
America (ACCA).
FIRE OR EXPLOSION HAZARD
Failure to follow the safety warning exactly
could result in serious injury, death or property
damage.
Never test for gas leaks with an open flame.
use a commercially available soap solution
made specifically for the detection of leaks to
check all connections. A fire or explosion may
result causing property damage, personal
injury or loss of life.
The
Simplicity
® control board used in this
product will effectively operate the cooling sys-
tem down to 0°F when this product is applied
in a comfort cooling application for people. An
economizer is typically included in this type of
application. When applying this product for
process cooling applications (computer rooms,
switchgear, etc.), please reference applica-
tions bulletin AE-011-07 or call the applica-
tions department for Unitary Products @ 1-
877-UPG-SERV for guidance. Additional
accessories may be needed for stable opera-
tion at temperatures below 30° F.
To Next Page
Loading...
