35
mounting position can be
mutually aligned.
4. Remove the objects.
5. Increase the sensitivity of
meeting obstacles.
Remote control doesn’t
work.
1. Low battery power of the remote
control.
2. Remote control learning is not
completed.
1. Change the remote control
battery.
2. Re-conduct remote control
learning.
Press OPEN, CLOSE
button, the gate doesn’t
run, and the motor has
noise.
Gate running is not smoothly.
According to the actual
situation to adjust the motor or
the gate.
Power supply line short circuit.
Remote control working
distance is too short.
Connect external receiver
antenna, should be 1.5 meters
above ground.
The gate moves to the
middle position to stop
or reverse.
1. Sensitivity of meeting obstacles
is too small.
2. Gate meets obstacle.
1. Increase the sensitivity
according to this manual.
2. Remove the obstacle.
Automatic close function has been
activated but with incorrect
opening direction.
Please refer to the relative
instructions in this manual to
change the opening direction.
To Next Page
Loading...
