20
4-1
ROTOR HEAD HUB ASSEMBLY
4-2
MAIN BLADE HOLDER ASSEMBLY
3x6mm Socket Head Bolt
........1 pc
3x8mm Socket Head Bolt
......2 pcs
2x10mm Flat Head Screw
........1 pc
Steel Joint Ball
........1 pc
3x6mm Self Tapping Screw
........4 pcs
Main Blade Holder Bearing
........2 pcs
Outer Main Blade Bearing Spacer
........1 pc
Inner Main Blade Bearing Spacer
........1 pc
3x6mm Socket Head Bolt
Use Threadlock
Use Threadlock
Head Button
3x8mm Socket Head Bolt
(2 pcs)
Two Sets Required
Main Blade Holder Bearing
Main Blade Holder
Main Blade Holder Bearing
Steel Joint Ball
2x10mm Flat Head Screw
Outer Main Blade Bearing Spacer
Inner Main Blade Bearing Spacer
3x6mm Self Tapping Screw
Use Blue Threadlock
Main Rotor Hub
Note: If you’re building the Ergo 46 3D CCPM
version, please refer to the separate assembly
instructions contained in the high cyclic
center hub assembly included with this kit.
To Next Page
Loading...
