JR ERGO - Page 58

58
Factory Pre-Set
Factory Pre-Set
XP652 HELI DATA SHEET ERGO 46 3D CCPM 3D SET-UP
D/R 90% 90%
EXP
D/R 100% 100%
EXP
TRIM OFFSET
CHANNEL THR (1) AIL (2) ELE (3) RUD (4) GER (5) PITCH (6)
NORM NORM NORM NORM NORM NORM
••••• •
REV REV REV REV REV REV
SUB-TRIM
TRAVEL ADJUST
(TRV ADJ.)
FAIL-SAFE (S-PCM)
REVERSE SW
*
FAIL-SAFE TIME (Z-PCM)
AILE (AI) ELEV (EL)
POS O
POS 1
L 2 H
N
S
N
S
H
THRO CURVE
TLN, T2N, THN,
TLS, T2S
PITCH CURVE
PLN, P2N, PHN,
PLS, P2S, PHS,
PLH, P2H, PHH
0% 50% 100%
100% 60%
-2° Pitch 5° Pitch 10° Pitch
-10° Pitch 0° Pitch 10° Pitch
-5° Pitch 5° Pitch 13° Pitch
DUAL
RATE
•
EXP
D/R SW
GEAR SW
REVO-MIX
(RV)
HOLD RUDD OFFSET
(OFFSET HLD)
UP (U)
±
DOWN (D)
+
–
THRO HOLD
(HLD)
ON OF
PROG. MIX
A
CHANNEL
MASTER SLAVE MIX SWITCH OFFSET +GAIN -GAIN
ON • F1 • FO • H
POSITION
±
Modulation S-PCM • Z-PCM • PPM (FM)
Model Number ___________________
Model Name ________________________
AIL (2) ELE (3) Pitch (6)
CCPM MIXING ON • OFF
+
–
60%60% 50%
+
–
+
–
AIL (2) ELE (3) RUD (4)
STUNT TRIM ON • OFF
+
–
+
–
+
–
Adjust Stunt Trim values as needed.
Ergo 46 3D CCPM 3D Set-up
Adjust as needed
Adjust for Idle
Refer to Revolution
mixing section of
manual for proper
settings
Refer to the CCPM section of this manual for proper settings
Adjust as needed
Adjust as needed