JR Vibe 90 3D - Elevator Control Arm Installation

15
Elevator Control Arm
*Standard Range Direction
Nylon Lock Nut, 4 mm
Flat Washer, 4 mm
Set Screw, 4 x 4 mm
2-3B
ELEVATOR CONTROL ARM INSTALLATION
90
Nylon Lock Nut, 4 mm
..................................1 pc
Flat Washer, 4 mm
...................................1 pc
Set Screw, 4 x 4 mm
....................................2 pcs
Use Red
Threadlock
Elevator
Control Arm
A-Arm Base
Make sure that the elevator control
arm is installed so that it is 90° to the
A-arm base. Use the locating hole in
the main frame to help achieve the
90-degree position.
Note:
Red
Red