2-5
MAIN FRAME ASSEMBLY: BOTTOM PLATE INSTALLATION
*
Socket Head Bolt, 3 x 10 mm (2 pcs)
Button Head Bolt,
3 x 10 mm (2 pcs)
Flat Washer, 3 mm (8 pcs)
Carbon Fiber
Bottom Plate
*
*
*
*
*
Tighten bolts at this time.
Remove a
3
/4" x 1
1
/4" portion of the clear coating from the top of the bottom carbon fiber plate as shown.
Remove a
3
/4" x
1
1
/4" portion of the
clear coating from
plate as shown.
3/4"
1-1/4"
When properly installed, the RF grounding bracket will make contact with both the two main frames and the bottom
carbon plate in the areas where the clear coating has been removed. This will properly complete the ground between
the main frame and the bottom carbon plate.
................4 pcs
..........................8 pcs
Socket Head Bolt, 3 x 6 mm
Flat Washer, 3 mm
............2 pcs
Button Head Bolt, 3 x 10 mm
............2 pcs
Socket Head Bolt, 3 x 10 mm
Use Red
Threadlock
To Next Page
Loading...
