JR Vibe 90 3D - Landing Gear Assembly Installation; Cooling Fan;Hub Installation

21
3-3
LANDING GEAR ASSEMBLY INSTALLATION
...2 pcs
..........................2 pcs
............................4 pcs
Socket Head Bolt, 3 x 20 mm
Nylon Lock Nut, 3 mm
Flat Washer, 3 mm
.........................4 pcs
Set Screw, 4 x 4 mm
TEAM TIP: The four 3 x 20 mm landing gear bolts can be installed
from the top (opposite diagram) for a cleaner appearance.
3-4
COOLING FAN/HUB INSTALLATION
Socket Head Bolt, 3 x 6 mm
Socket Head Bolt, 3 x 6 mm (4 pcs)
..................4 pcs
4 pcs
Nut (supplied with engine)
Washer
(supplied with engine)
Use for O.S. engines
only. Omit for YS
engines.
Taper Collet Upper (small)
Taper Collet Lower
(large)
...........................4 pcs
Flat Washer, 3 mm
Flat Washer, 3 mm (4 pcs)
Cooling Fan
Blades
Cooling Fan Hub
Use Red
Threadlock
*
*
*
*
*
Tighten bolts evenly
to prevent warping.
TEAM TIP: It is recommended that a
crankshaft (not piston) locking tool
be used to properly secure the fan
assembly to the engine.
Socket Head Bolt, 3 x 20 mm (2 pcs)
Nylon Lock Nut, 3 mm (2 pcs)
Flat Washer, 3 mm (4 pcs)
Set Screw, 4 x 4 mm (4 pcs)
Antenna Tube
Landing Skid (2 pcs)
Landing Struts (2 pcs)
Landing Skid Cap
Use CA adhesive
to attach.
Red