JR Vibe 90 3D - Landing Gear Assembly Installation

19
2-7
FRONT RADIO BED INSTALLATION
3-1A
MAIN DRIVE GEAR/AUTOROTATION ASSEMBLY
Socket Head Bolt 3 x 8mm
Socket Head Bolt, 3 x 6 mm
Main Drive Gear
88T
Autorotation Assembly
Autorotation Assembly
Direction
(Note correct direction
during assembly.)
Socket Head Bolt, 3 x 6 mm (4 pcs)
(Tighten equally to prevent warping of main drive gear)
Socket Head Bolt, 3 x 8 mm (4 pcs)
Socket Head Bolt 3 x 10 mm
Body Mounting Standoff 24 mm
Cross Member 48 mm
Cross Member,
48 mm
Special Cross
Member, 48 mm (2 pcs)
Flat Head Bolt,
3 x 6 mm (4 pcs)
Carbon Radio Bed
................................................4 pcs
..............................................4 pcs
...................2 pcs
...................4 pcs
.......1 pc
Up
*Apply a light
coating of grease to
torrington bearing.
Use Red
Threadlock
Use Red
Threadlock
*TEAM TIP: Apply a light coating of high speed
grease to the inside of the torrington bearing.
Red
4pcs
Flat Head Bolt, 3 x 6 mm
...................... 4 pcs
Red
Body Mounting
Standoff, 24 mm (2 pcs)
Red
Red
Red
Red
Socket Head Bolt, 3 x 10 mm (4 pcs)
Body mounting
standoffs attach
to the forward-
most holes in the
tank mounts
as shown.
Note: