JR Vibe 90 3D - CCPM Servo Centering with the Sub-Trim Function

52
1. XP9303 SYSTEMS
1) With the radio power switch on, press the ENT key to enter the function mode.
2) Move the roll selector until until “Sub Trim” appears on the screen, then press.
3) Adjust the left (CH-2), right (CH-6), and top (CH-3) servos as needed until the servo arm is exactly parallel
to the servo when the collective stick is in the center position.
4) Move the roll selector to LST to exit the Sub Trim function.
2. XP8103 SYSTEMS
1) With the radio power switch on, press the Up and Down keys simultaneously to enter the function mode.
2) Press the Up key until “Sub Trim” appears on the screen.
3) Adjust the left (aileron), right (Aux 1), and top (elevator) servos as needed until the servo arm is exactly
parallel to the servo when the collective stick is in the center position. It will be necessary to press the SEL
key once to access the right servo (Aux 1) sub-trim.
4) Press the Up and Down keys simultaneously to exit the function mode.
[Sub Trim]
£THRO ∞AILE
00
ELEV RUDD
00
[Sub Trim]
£GEAR ∞ PIT.
00
AUX2 AUX3
00
Increase or decrease
the value to center
the front servo.
Increase or
decrease the value
to center the right
servo.
Increase or decrease
the value to center
the left servo.
SEL
3. JR PCM10, 10S, 10SX, 10SXII, 10X SYSTEMS
1) Enter the sub-trim function (code 15).
2) Adjust the left (aileron), right (Aux 1) and top (elevator) servos as needed until the servo arm is exactly
parallel to the servo when the collective stick is in the center position. It will be necessary to press the Page
button to access the right servo (Aux 1) sub-trim value.
3) Press Enter to exit the sub-trim function.
[SUB TRIM]
THRO AILE ELEV RUDD GEAR
00000
ENTER
PAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
+ –
CL
Press Page to access
the second screen.
Increase or decrease
the value to center
the left servo.
Increase or decrease
the value to center
the front servo.
[SUB TRIM]
PIT. AUX2 AUX3 AUX4 AUX5
00000
ENTER
PAGE
+ –
CL
+ –
CL
+ –
CL
+ –
CL
+ –
CL
Increase or decrease the value
to center the right servo.
It may be necessary to make minor servo centering adjustments with the use of the sub-trim function to
achieve the desired servo arm positions. Please refer to your particular radio’s section as listed below or consult
your radio instruction manual for more information.
7-2
CCPM SERVO CENTERING WITH THE SUB-TRIM FUNCTION
[Sub Trim]
THRO 0 GEAR 0
AILE 0 PIT. 0
ELEV 0 AUX2 0
RUDD 0 AUX3 0
AUX4 0