JR Vibe 90 3D - Main Frame Assembly: Engine Mount;Cross Member Installation

16
2-4
MAIN FRAME ASSEMBLY: ENGINE MOUNT/CROSS MEMBER INSTALLATION
Remove a 1/2" x 1/2" portion of the clear coating from the inside of each
main frame as shown.
.....3 pcs
....6 pcs
.....................................9 pcs
Socket Head Bolt, 3 x 40 mm
Socket Head Bolt, 3 x 50 mm
Nylon Lock Nut, 3 mm
Up
O.S. Engines and YS Engines
Engine Mount Direction
*TEAM TIP: Do not tighten bolts completely at this
time. These bolts will be tightened in Step 3-8.
Socket Head Bolt, 3 x 50 mm (3 pcs)
Cross Member B
(note correct direction)
Rear Grounding Bracket
Socket Head
Bolt, 3 x 40 mm
(6 pcs)
Socket Head
Bolt, 3 x 50 mm (1 pc)
(Do not use threadlock.)
*
*
*
*
*
*
*
Remove a 1/2" x 1/2" portion of the clear
coating from the inside of each frame plate
as shown.
*
*
Nylon Lock
Nut, 3 mm
(8 pcs)
1/2"
1/2"
Cross Member B
(note direction)
Landing Struts
Adaptor (4 pcs)