JR Vibe 90 3D - Servo;Switch Harness Installation

39
6-3
SERVO/SWITCH HARNESS INSTALLATION
................20 pcs
Self Tapping Screw, 2.6 x 12 mm
...............................20 pcs
...........................8 pcs
Flat Washer, 2.6 mm
CA Stopper Ring, 3.5 mm
Type-B Servo Mounting Plate
....................10 pcs
.............2 pcs
Self Tapping Screw, 2.6 x 15 mm
CA Stopper Ring, 3.5 mm
Type-B Servo
Mounting Plate
* Note correct servo
output shaft orientation
during installation.
Attach as shown.
Type-B Servo
Mounting Plate (10 pcs)
Self Tapping Screw, 2.6 x 12 mm (10 pcs)
Self Tapping Screw, 2.6 x 15 mm (2 pcs)
*This portion only. (without washer)
Flat Washer, 2.6 mm (10 pcs)
Collective Servo
(Ch6)
Elevator Servo
(Ch3)
Aileron Servo
(Ch2)
Note output
shaft direction.
A
A
B
C
C
*
Self Tapping
Screw, 2.6 x 12 mm (8 pcs)
Switch Dampener
Rubber (2 pcs)
Switch Harness
Screws Supplied
with Switch
Flat Washer, 2.6 mm (8 pcs)
Switch
Switch Plate
Dampener Rubber
(2 pcs)
Off
On
Rudder
Servo
Throttle
Servo
TEAM TIP: When installing the
switch harness, position it so
that "Up" is off and "Down" is the
on position. This will prevent the
switch from accidentally being
turned off in a hard landing
or auto.
B