JR Vibe 90 3D - Swashplate;T-Arm Control Rod Installation

4-6
SWASHPLATE/T-ARM CONTROL ROD INSTALLATION
1
2 4
3.5 mm
12.5 mm 42 mm
SWASHPLATE TO T-ARM
(Threaded Rod 2.3 x 60 mm)
WASHOUT ARM TO FLYBAR CONTROL ARM
(Threaded Rod 2.3 x 30 mm)
SEESAW ARM TO MAIN BLADE HOLDER
(Threaded Rod 2.3 x 15 mm)
Universal Ball Link (short)
................................2 pcs
.......2 pcs
....2 pcs
Universal Ball Link
Universal Ball Link
3
32.5 mm
SWASHPLATE TO SEESAW ARM
(Threaded Rod 2.3 x 50 mm)
....2 pcs
Universal Ball Link
Please note that all universal
links should be adjusted so that
when attached to the control
ball, the words “JR PROPO”
are to the outside.
Caution:
TEAM TIP: The JR ball links are designed with little
ridges around the lip of the link. These ridges, in
conjunction with the JR ball link sizing tool, are there
to help you custom fit the link to the ball. If the link
fits on the ball too tight, you can use the reaming tool
to enlarge the link hole size. If the link fits too loose
on the ball, you can push in on the ridges on the link
with a small pair of pliers. This reduces the size of the
link hole and makes the link fit tighter. JR links are
some of the best links available. It is important to note
that very little force is needed on the ridges to resize
the link. Using pliers on any other part of the link can
cause the links to break.
TEAM TIP: After many flights there
can be excess play between the
ball and link. It is usually the ball
that has actually worn. So when
replacing parts, you will actually
get the best results by replacing
the balls.
1
2
4
3
29
Use JR Ball Link
Sizing Tool