JR Vibe 90 3D - Main Rotor Blade Attachment (Blades Not Included)

66
5 mm bolts are placed top down,
4 mm bolts are inserted bottom up.
Note:
8-3
MAIN ROTOR BLADE ATTACHMENT (BLADES NOT INCLUDED)
Lock Nut, 4 mm
Socket Head Bolt, 4 x 35 mm
.........................................2 pcs
............2 pcs
Lock Nut, 5 mm
.........................................2 pcs
Socket Head Bolt, 5 x 35 mm
............2 pcs
Main Rotor Blade Spacers, 4 mm
(12 mm Grip)
...................................4 pcs
Two sets required
Insert the main rotor blade spacers as shown.
Apply a light drop of CA
adhesive to hold the main
rotor blade spacers in place.
Firmly secure the main
rotor blades to the rotor
head as shown above. Be
sure to note the proper
direction of the rotor
blades when assembling
(clockwise rotation). Main
blades should be tightened
so they can pivot when
moderate pressure is
applied. Do not allow the
main blades to swing
freely within the main
blade holders.
Hold the 4 mm Lock Nut while tightening
using a Wiha 7 mm Nut Driver or equivalent.
Lock Nut, 4 mm (1 pc)
12 mm
Socket
Head Bolt,
4 x 35 mm (1 pc)