JR XP810-3 - Page 79

www.modelflight.com.au – World’s best source of JR products
4 . 8 Throttle Cu
r
ve
(
Function Mode
)
, cont.
Throttle Point Examples
Inactivated Point #1
INH means that this point is
currentl
y
inhibited
Middle Point
factor
y
p
re-set at 50%
Press either the + or - keys
to activate and adjust the
p
oint shown at the cursor
CLEAR
Press the Clear key to return
the point value at the cursor to
the factory preset, or INH
p
osition
When a particular point i
s
activated, the output valu
e
will then be dis
p
la
y
ed
Middle point 1 is activated
(
out
p
ut value = 25%
)
A
ctivated Point #1
Throttle
T
rim Setting
The throttle trim lever is only active when the flight mode switc
h
is in the normal position. The throttle trim is used to increase o
r
decrease the engine RPM to achieve a reliable idle when in th
e
Nor mal Mode. The throttle trim lever has no ef fect at position 1,
2, Stunt 1 or Stunt 2, or throttle hold.
Hovering Throttle Knob Setting
The hovering throttle knob increases or decreases the engine
output power for either the center point only (point #2), or
middle three (3) points, if activated, of the throttle cur
ve. As
shown in the figures below , use of the hovering throttle knob
shifts the middle cur ve upward or downward. Therefore,
operation of the hovering throttle knob does not cause any
change to the high point and low point of the throttle curve.
Throttle
T
rim
Operating
Range
Hovering Throttle Knob
O
p
eratin
g
Ran
g
e
Output value
The hovering throttle
knob adjusts all middle
points that are activated
in Normal Mode
(Points 1 and 3)
Th
r
ottle
T
rim
Operating
Range
Hovering Throttle Knob
Operating Range
(all points are
parallel)
Output value
When points 1, 2, & 3
are activated, the
Hovering Throttle Knob
will increase/decrease
all 3 points together
Point L
Throttle Stick
Low Hi
g
h
Point L
Throttle Stick
Low Hi
g
h
HELI 79