4. Operation 19
Setting Cursor Display
٧The cursor display method in a standard mode and a history mode is selected.
Make CURSOR a yellow display, press or the [ENT] key, and select it from the following, set content.
Set content 㧦 OFF/ON/AUTO
OFF 㧦 When the cursor key is operated, it makes an error of the cursor without displaying it.
ON 㧦 Whenever the cursor key is operated, the cursor is displayed.
AUTO 㧦 When the cursor key is operated, the cursor is displayed for 30 seconds. It doesn't
display afterwards. When the cursor key is pressed again, it is displayed at the
position.
Select the method by and press the [ENT] key.
To Next Page
Loading...
Need help?
General
