JRC JHS-32B - Page 93

1
2
3
4
5
6
7
8
9
10
85
OPERATION
4.3 Communicating in DSC (Digital Selective Call) Mode
TIP
• If the message is not acknowledged, the display
remains.
• If the message is not acknowledged, press
CALL
again to transmit the message.
• Press
STOP
to end the transmisson.
When the message is acknowl-
edged, an alarm sounds.
• The CH70 display changes to the work
channel display.
• Press
STOP
to stop the alarm.
The work channel display appears
10 seconds after the message is
acknowledged.
The INDIVIDUAL CALL Display disappears and
the work channel Status Display appears.
TIP
When the handset is picked up before the work
channel Status Display appears, the display
appears immediately.
Start the transmission.
Press PTT to transmit.
Hang up the handset to terminate
communication.
The CH16 Status Display returns and OFF
appears for OPE in the display.
TIP
When no remote controllers are connected,
MASTER remains for OPE.
JHS-32B
MARINE VHF RADIOTELEPHONE
JHS-32B
MARINE VHF RADIOTELEPHONE
ITU
CH 10
MODE: SIMP TEL OUTPUT: 25W
OPE : MASTER ALARM : ENABLE
SCAN: OFF SQL : CLOSE
SP : ON POWER : AC
21 JUL 1994 14:59 UTC
S: 12°34’ W: 123°45’ U
--INDIVIDUAL CALL--
CH10 25W
FORMAT :INDIVIDUAL
ADDRESS :483192657
CATEGORY :ROUTINE
TELECOMMAND1 :G3E SIMP TEL
TELECOMMAND2 :NO INFORMATION
WORK CH :10
END OF SEQUENCE:ACK RQ
CALL CH :70
TRANSMITTED
PRESS STOP TO RETURN.