JRC JHS-32B - 4.2.5 Scanning Feature

60
OPERATION
4.2.5 Receiving Using the Scanning Feature
In scanning mode, the unit searches automatically for receivable signals. The three scanning modes
are described below.
• ALL CH SCAN : Scans all channels in the selected region.
• MEMORY CH SCAN : Scans all channels (up to 10) that are saved as memory channels.
• SELECT CH SCAN : Scans all channels in the selected range.
OPERATION
Press
OPE
.
MASTER appears for OPE in the CH16 Status
Display.
TIP
• When no remote controller is connected,
pressing
OPE
is not necessary because
MASTER automatically appears for OPE.
• A controller which does not have priority can be
used only when no other controller is in use
[OPE: OFF], by just pressing the
OPE
key.
When using the controller which has priority,
pick up the handset or press
OPE
to make a
call.
Press
SCAN
.
The SCAN Display appears.
Select a scanning mode using
/
.
The selected scanning mode is highlighted.
ITU CH 16
MODE: SIMP TEL OUTPUT: 25W
OPE : MASTER ALARM : ENABLE
SCAN: OFF SQL : CLOSE
SP : ON POWER : AC
21 JUL 1994 14:59 UTC
U
ITU CH 16
MODE: SIMP TEL OUTPUT: 25W
OPE : MASTER ALARM : ENABLE
SCAN: OFF SQL : CLOSE
SP : ON POWER : AC
21 JUL 1994 14:59 UTC
S: 12°34’ W: 123°45’ U
4.2 Communicating Using a Specified Channel
--SCAN--
CH16 25W
1.ALL CH SCAN
2.MEMORY CH SCAN
3.SELECT CH SCAN ITU CH
FORM CH TO CH
SELECT WITH , & PRESS ENTER .
PRESS STOP TO RETURN.
--SCAN--
CH16 25W
1.ALL CH SCAN
2.MEMORY CH SCAN
3.SELECT CH SCAN ITU CH
FORM CH01 TO CH88
INPUT CH NO., & PRESS ENTER .
PRESS CLR TO CORRECT.
PRESS STOP TO RETURN.