No. Item Setting range Edit unit Remarks
Flow bar-tacking offset, left
This item sets length to form bar-tacking
sectionofowbar-tackingshape.
0.00 to 3.00 0.05mm ※1
Flow bar-tacking offset, right
This item sets length to form bar-tacking
sectionofowbar-tackingshape.
0.00 to 3.00 0.05mm ※1
Eyelet shape length
This item sets upper side length from center of
eyelet of eyelet shape.
1.0 to 10.0 1 ※1
Number of stitches of eyelet shape
This item sets number of stitches in the upper
90ﾟofeyeletshape.
1 to 8 0.1mm ※1
Eyelet width
This item sets crosswise size of the inside of
eyelet shape.
Actual needle entry point is the dimension to
which S04 Knife groove width, left is added.
1.0 to 10.0 0.1mm ※1
Eyelet length
This item sets lengthwise size of the inside of
eyelet shape.
1.0 to 10.0 0.1mm ※1
Round type shape length
This item sets upper side length from the
center of round type shape.
1.0 to 5.0 0.1mm ※1
Number of stitches of radial shape
This item sets number of stitches in the upper
90° of radial shape.
1 to 8 1 ※1
Round
type, top
Radial, top Semilunar,
top
Round
type,
bottom
Radial,
bottom
Semilunar,
bottom
To Next Page
Loading...
