– 43 –
No. Item Setting range Edit unit Remarks
Reinforcement of radial shape
This item sets with / without reinforcement
stitching
of radial shape.
--- --- ※1,※2
: With : Without
Pitch at bar-tacking section
This item sets sewing pitch of bar-tacking
section.
0.100 to
2.500
0.025mm ---
1st clearance
This item sets the clearance between 1st
bar-tacking and knife groove. This item is
applied to all shapes.
0.0 to 4.0 0.1mm ---
2nd clearance
This item sets the clearance between 2nd
bar-tacking and knife groove. This item is
applied to all shapes.
0.0 to 4.0 0.1mm ---
Single/double stitching
This item selects single or double stitching.
--- --- ---
: Single stitching :
Double stitching
Square
type, top
Round
type,
top
Semilunar,
top
Square
type,
bottom
Round
type,
bottom
Semilunar,
bottom
Straight
bar-tack,
bottom
Flow,
bottom
To Next Page
Loading...
