ā 85 ā
Item Setting range Edit unit Initial display
KNIFE CYLINDER LOWERING TIME
(OPTIONAL)
5 to 300 5ms 70
Y-feed motor origin compensation
-120 to 400 1 pulse
(0.025 mm)
0
Needle-rocking motor origin
compensation
-10 to 10 1 pulse
(0.05 mm)
0
Presser lifter motor origin
compensation
-100 to 10 1 pulse
(0.05 mm)
0
Display/Non-display of direct button
--- --- Non-display
: Display
: Non-
display
Thread trimming on the way in continuous
stitching Permitted/ Prohibited.
In case of prohibited, jump feed setting becomes
invalid, and the registered pattern is sewn at the same
position. Then multi-sewing is possible.
--- --- Permitted
: Permitte : Prohibit
Changeover of cloth cutting knife
return power
This item sets output power at the time of
returning the cloth cutting knife.
0 to 3 1 0
Release amount of bobbin thread
trimmer at the start of sewing
This item sets the amount of releasing
the bobbin thread trimmer at the start of
sewing.
1 to 15 1 pulse 8
Presser lifter speed selection
1 to 3 1 1
To Next Page
Loading...
