9-5
Finishing the operation
Press the CANCEL button in to return to . Press the CANCEL button in to return to
the menu screen.
9-5. Shuttle valve
The condition of the vacuum sensor is displayed by making the shuttle suction valve to each of
the following states: Vacuum, Vacuum destroy, and Stop.
To change the suction pad, see the menu 9. “Concentric Nozzle”.
Starting the shuttle suction valve operation
Select “4. Shuttle Vacuum” in the menu.
Use ↑ and ↓ buttons to select left, right, or left-and-right pads.
Use → and ← buttons to move the cursor ∗ and select Vacuum (VCM), Vacuum destroy
(DES), or Stop (STP).
The condition of the vacuum sensor is kept displayed as “ON” or “OFF”.
Fig. 9-5-1 Condition of shuttle valve
Finishing the operation
Press the CANCEL button to return to the menu screen.
9-6. Head
The suction head is driven independently. You can select continuous or single operation mode.
The time required for driving the head is also displayed.
Starting head operation
Select “5. Head” in the menu.
Use → and ← buttons to move the cursor ∗ and select the operation speed. Press the
ENTER button.
Fig. 9-6-1 Selection of head speed
∗ Slow2 is effective only when the optional “slow 2 mode” is set.
If Slow2 is selected with “slow 2 mode” not being set, “Normal” head operation will be
conducted.
Selecting head
Use → and ← buttons to move the cursor ∗ and select the suction head No. Press the
ENTER button.
Fig. 9-6-2 Selection of head
VCM L-OFF R- ON L R
∗Normal Slow2
To Next Page
Loading...
Need help?
General
