36
Throttle Reverse: Check to reverse the throttle.
Throttle Source: Defines the joystick that triggers the THx option, typically set to
throttle.
Throttle Trim Idle Only: IC engine mode.
Preflight Checks: A set of security features that take effect when the remote is
powered on or when the model is loaded from the model list.
Display checklist: If a text file with the same name as the model is placed in the
MODELS folder of the SD card, the remote will recognize it as a model check list. If this
option is checked, the file will be displayed automatically.
Throttle State: Check to check if the throttle stick is idle.
Switch Positions: Defines the position of the switch for remote control check. You
can select the settings separately, or you can first switch the switch to the position you
want to define, then select all the switches and then press and hold the ENT key to set.
Pots&Sliders: This also applies to analog control. There are 2 modes when
enabled. When Auto and Man. are set to Auto, the potentiometer and slider position will
be automatically stored when the remote is turned off or other models are loaded. When
set to Man, you need to press and hold the ENT key on the potentiometer and slider icon
to be saved.
Center beep: Set the channel through the neutral point prompt, select the channel to
be set and press and hold the ENT key (default gray, indicating no prompt, black means
enable, there will be sound and vibration prompt when the corresponding channel
passes the neutral point)
Use Global Functions: Check if the global function is used. By default, it is checked
when the model is created.
Internal RF:
Mode: The transmission mode of the internal RF RF module. It must match the
type supported by the receiver, otherwise it will not be able to match the frequency.
OFF: Turn off the internal RF RF module.
To Next Page
Loading...
