35
Timers: There are 3 timers that can be set to count up or down. If set to 00:00:00, they will start
from 0, otherwise they will count down.
Source: Set how to trigger the timer. When set to ON, it will always count. When set to
THs, the throttle will start timing. When the throttle is at the lowest, stop timing. Set to THt to
push the throttle to start timing. The throttle minimum timing will not stop. Set to TH%. It is
based on the throttle percentage, and can also be set to use the switch, joystick or flight mode
to trigger.
Name: Set the timer name.
Persistent: Allows the value of the timer to be stored in memory when the remote is shut
down or when the model is changed, and reloaded the next time the model is used. If set to
Flight, select Reset Flight and the timer will be reset. If it is set to Manual Reset, you need to
manually select the corresponding Reset time to reset the timer (for example, Timer 1 is set to
Manual Reset, you need to manually select Reset. Time1 to reset the timer)
Minute call: If you check it, you will beep or say every minute for every minute.
Countdown: Can be set to Silent, Beeps, Voice or Haptic. If set to Silent, the timer will
remain muted until 0, and a voice prompt will appear as soon as it reaches zero. If set to
Beeps, the beep will be prompted when there is 30 seconds left in the countdown (set to 10s,
every 10 seconds when the countdown is left, every second will be prompted, when set to 20s,
the remaining 20 seconds will start every One second prompt, when set to 30s, it will be
prompted every second for the remaining 30 seconds). If set to Voice, the effect is the same as
Beeps, except that the beep is replaced with a voice prompt. If set to Haptic, the effect is the
same as Beeps, except that the beep is replaced with a vibrating alert.
Extended limits: Check to expand the channel travel to 150%.
Extended trims: Check to expand the fine-tuning range. This option must be used with care
because keeping the spinner label too long may add too much fine-tuning to make your model
unusable. Reset will reset all fine adjustments (for all flight modes)
Display Trims: Can be set to No, Change or Yes. If set to "Change", the fine-tuning value
will be displayed briefly after changing the fine-tuning and then disappear.
Trim Step: Set the fine adjustment step precision. Set to Exponential to indicate that the
trimming value is very fine near the neutral point of the channel, and the farther away from the
neutral point, the worse the step accuracy.
To Next Page
Loading...
