44
It is highly recommended to always create a last line that is not restricted
by the switch or flight mode. This is to ensure that even if an invalid logic or
switch failure invalidates other lines, at least the line will still be active, thus
avoiding this. One channel cannot be controlled.
The rate sets the ratio of joystick movement to channel movement. In
each of the three processing layers (Inputs, Mixer, and Outputs), each has a
rate (=Weight) parameter. These rates are cumulatively applied, so the final
servo command is the product of all rates:
OutputValue= SourceValue x InputWeight x MixerWeight x OutputRate
(note that OutputRate is a function of Min/Max and curve settings).
Initially keep all input (Inputs), Mixer (Outputs) and Output (Outputs)
rates as default (100%)
In the “Outputs” menu, adjust Min/Max to get the maximum stroke within
the mechanical limit while ensuring that the paired control surfaces have the
same stroke. Alternatively, you can use the Outputs curve to set these limits.
Press and hold the ENT key to select Edit and enter the input settings
page.
To Next Page
Loading...
