73
05.10 EN
4.2.1 Starting procedure for the DFG
Procedure
• Insert the key in the key switch (79). Set
the key switch to “I”.
• The pre-heat indicator lamp lights up and
goes out automatically as soon as the
required pre-heat time (approx. 4
seconds) has been reached.
• All the indicators go on briefly as a
function check and the (100) display is
activated.
Z All the warning indicators apart from the
engine oil pressure display (86), parking
brake (87), truck
operational indicator light (95) and
charge current warning light (91) should
go out after a short while. If not, stop the
start-up process and rectify the fault.
• Press the start button (78).
Z Only apply the starter for a maximum of
15 seconds without interruption. The truck contains a restart blocking mechanism
which prevents it from starting again while the engine is running.
• Release the start button as soon as the engine starts.
• Test the brake pedal and parking brake.
The truck is now ready for operation.
Z All indicators except for the parking brake
(87) and the truck operational indicator
(100) should go out as soon as the engine
starts. If not, stop the engine immediately
and rectify the fault.
km/h
R
69
9086 9187 95
100
S
T
A
R
T
78
79
To Next Page
Loading...
Need help?
General
