Juniper CTP2024 User Manual

CHAPTER 13
Installing and Removing SFPs in a CTP
Module
•
Installing SFPs in a CTP2000 Module on page 95
•
Removing SFPs in a CTP2000 Module on page 96
Installing SFPs in a CTP2000 Module
This section describes how to install small form-factor pluggable transceivers (SFPs)
on interface modules that support these devices. In the current release, the
CTP-FX2000GE-UPG supports SFPs.
You can replace the SFPs without disabling the interfaces or removing the module from
the device.
To install SFPs:
1. Ground yourself by using an antistatic wrist strap or other device, and connect it to
an ESD grounding jack.
2. Identify the following items on the SFP (Figure 37 on page 96):
•
The connection circuitry on the base
•
The cable connectors on the front
95Copyright © 2017, Juniper Networks, Inc.

Juniper CTP2024 Specifications

General

Brand	Juniper
Model	CTP2024
Category	Network Hardware
Language	English