Juniper CTP2024 User Manual

To unpack the device:
1. Cut the two straps that secure the carton to the skid, open the carton from the top,
and remove the box of accessories that sits on top of the device.
2. Unlock the four plastic clips that hold the box to the skid by squeezing them in their
center and pulling out, and then lift the carton off the device.
3. Remove the three screws that attach each of the two L-brackets to the device.
4. To avoid scratching the device when removing it from the skid, detach one of the
L-brackets from the skid by removing the three screws.
Related
Documentation
Before You Unpack the CTP Platform on page 79•
• Inspecting Platform Components and Accessories on page 80
• If You Detect or Suspect Damage on page 80
• Contacting Juniper Networks on page 81
Inspecting Platform Components and Accessories
After you remove the equipment from the shipping containers:
•
Confirm the contents of each container.
•
Inspect all external surfaces and external connectors for visible signs of damage.
•
Inspect all accessories shipped with each unit.
•
Document any damage noted during your inspection.
•
Confirm that the platform has the correct number and type of modules for your ordered
configuration.
Related
Documentation
Before You Unpack the CTP Platform on page 79•
• Unpacking the CTP Device on page 79
• If You Detect or Suspect Damage on page 80
• Contacting Juniper Networks on page 81
If You Detect or Suspect Damage
If you detect or suspect damage to any equipment:
•
Contact the shipper responsible for delivery, and formally report the damage.
•
Contact your Juniper Networks sales representative or reseller.
Related
Documentation
Before You Unpack the CTP Platform on page 79•
• Unpacking the CTP Device on page 79
Copyright © 2017, Juniper Networks, Inc.80
CTP2000 Hardware Documentation

Juniper CTP2024 Specifications

General

Brand	Juniper
Model	CTP2024
Category	Network Hardware
Language	English