During initial power-on, the components of the platform run boot code, go through a
series of self-diagnostic tests, and synchronize with each other.
When the tests are complete, use the LEDs on each module to determine the status of
the device. Observe the module LEDs on the front or rear components.
Related
Documentation
Before You Power On the CTP2000 Platform on page 107•
• Powering Off the CTP Platform on page 110
Powering Off the CTP Platform
Use one of the following methods to power off the device:
•
Using the halt Command at the CTP Command Line
•
Using the CTP Menu
To power off the CTP platform from the CTP command line:
Before you power off the device, enter the halt command to temporarily suspend the
device's operation.
CAUTION: If you do not use the halt command before removing or powering
down the device, the device's CompactFlash card might become corrupted.
To power off the device from the CTP Menu:
1. From the Main Menu, select 5) Node Operations.
2. From the Node Operations Menu, select 10) Powerdown Node.
Copyright © 2017, Juniper Networks, Inc.110
CTP2000 Hardware Documentation
To Next Page
Loading...
Need help?
General
