EasyManuals Logo
Home>Juniper>Network Hardware>CTP2024

Juniper CTP2024 User Manual

Juniper CTP2024
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
For example:
...
*********** Setting up the root password ************
Changing root's password!
Changing password for user root.
New password:
Retype new password:
BAD PASSWORD: it is too short
passwd: all authentication tokens updated successfully.
************** Setting up the network ***************
Configure supported protocols:
0) IPv4 Only
1) IPv6 Only
2) IPv4 and IPv6
Please select your option (rtn for 0):
There are 4 ethernet devices available for use. The default device
is the device through which the default gateway can be accessed.
Ctp circuits can run over any ethernet device, default or not.
A default device must be configured, other devices may be configured
and enabled, or disabled. Here is a list ot the available devices
and their descriptions:
eth0: 10/100/1000 Copper (front)
eth1: 10/100/1000 Copper (back)
eth2: 1000 Fiber (left)
eth3: 1000 Fiber (right)
What device would you like to make the IPV4 default device? (rtn for eth0): eth1
OK, eth1 (10/100/1000 Copper (back)) will be configured as IPV4 default device.
Please input the hostname (return for (none)): nova_54
===== Configuration for eth1 (default device):
Please input the ip (return for 127.0.0.1): 172.25.61.54
Please input the netmask (return for 255.255.255.0): 255.255.255.128
Please input the gateway (return for 127.0.0.1): 172.25.61.1
Please input the mtu in bytes (return for 1500):
Add route to interface eth1 [n]
======================================
=== OS Security level set to LOW ===
======================================
************** Setting up date/time *****************
Setting the date (GMT). Please input the year [2008-2020] (return for 2010):
Setting the date (GMT). Please input the month [1-12] (return for 01):
Setting the date (GMT). Please input the day [1-31] (return for 11):
Setting the date (GMT). Please input the hour [0-23] (return for 20):
Setting the date (GMT). Please input the minute [0-59] (return for 22):
INIT: Entering runlevel: 3
Entering non-interactive startup
...
109Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Powering On

Table of Contents

Other manuals for Juniper CTP2024

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper CTP2024 and is the answer not in the manual?

Juniper CTP2024 Specifications

General IconGeneral
BrandJuniper
ModelCTP2024
CategoryNetwork Hardware
LanguageEnglish

Related product manuals