Juniper Geode GNS3 - Advanced; Battery Status Sentence; NMEA Precision ▶ Mask Angle ▶ Correction Source ▶ SBAS; Receiver Mode

Chapter 9 Learn Geode Connect for Windows PC 131
Owner's Manual
Update Rate
The update rate sets the
message output rate
through the active port.
Note: Changes must be
saved in order for them
to remain from screen to
screen. If the save icon in
the lower right corner of
the screen is orange, this
means there has been a
change that needs to be
saved. Tap the save icon to
save your changes .
To upgrade the update rate,
see 9.5.4 Upgrade Geode
on page 142.
Advanced
The Advanced screen
allows you to configure
the following advanced
settings for the Geode.
■ NMEA Precision
■ Mask Angle
■ Correction Source
■ SBAS
■ Receiver Mode
■ Battery Status Sentence
■ Receiver Reset