22 Chapter 3 Getting Started
Geode GNS3 Real-Time Sub-Meter GPS Receiver
3.2 Turn on the Geode
To turn on the Geode, press and release the power key .
The green LED Activity Indicator turns on.
3.2.1 Reset the Geode
You can perform a soft or receiver reset for the Geode using
the power key by following the instructions below.
Soft Reset
A soft reset will set the Geode back to the default settings.
To perform a soft reset,
1. Press and hold the power key for 5 seconds.
2. When the LED Activity Indicator flashes slowly, release
the power key.
The Geode will perform a soft reset then turn off when the
reset is complete.
Receiver Reset
A receiver reset will set the Geode back to the factory
settings. To perform a receiver reset,
1. Press and hold the power key for 15 seconds.
2. When the LED Activity Indicator flashes quickly, release
the power key.
The Geode will perform a receiver reset then turn off when
the reset is complete.
To Next Page
Loading...
Need help?
General